It was pointed out to me that when making a full circle (360 degree) pipe using my Bent Pipe generator, the pipe turns sold rather than remain hollow.
Is there something I can tweak to prevent that?
It was pointed out to me that when making a full circle (360 degree) pipe using my Bent Pipe generator, the pipe turns sold rather than remain hollow.
Is there something I can tweak to prevent that?
Good catch. The hole without outlet can be ignored during the final mesh generation via Tinkercad Gen6 kernel. If you need a hollowed torus, one workaround is to group two toruses one solid one hole (with smaller size), then the hole can be preserved.
Fair enough, but I can't really do that in the generator. Someone else noted it in a comment rating the generator. I guess the other option would be to limit it to 359 degrees.