I constructed a design in TinkerCad with a length of 112mm - when it was printed it was only 105mm - any thoughts?
Cheers..........Doug
I constructed a design in TinkerCad with a length of 112mm - when it was printed it was only 105mm - any thoughts?
Cheers..........Doug
Hey Doug
Depending on the printer, there can be some shrinkage/tolerance ranges. Can you see the STL dimensions in whatever printer driver you're using? If they are consistent with your original model, you may need to bump up the % or shells to take into account the heating/cooling of the plastic.
Thanks Andy - I'll obviously have to investigate further......