Motor Mount for RC model

I want to design a motor mount for an RC model.
Because pictures say more than words I have attached two images. The RC model is made of foam and the motor is in a plastic housing. A lot of people and I had the problem, that the motor broke off at a landing. It’s just a bad design. I want to cut about 5mm of the foam away and design a 3D printed motor mount that is glued to the foam and holds the plastic piece with arms that go into the plastic part. The difficult part is that the plastic piece is not cylindrical but conical.
On the images you can see the plastic piece with the electric motor inside and the fuselage, which is upside down. The plane is a pusher.
How can I design a motor mount with TinkerCAD?

1 comment

Please sign in to leave a comment.