When starting simulation with Arduino, receive an error message.
22 comments
-
Christian Official comment It looks like this was temporary...the compiler is now operational.
-
Cleared I'm also getting this problem last 3h.
-
Alex Sneed Miller I'm getting the same error again now. Is it down for everyone else too?
I am on a corporate network though, any chance that can be messing it up?
-
Christian -
Christian This issue has been resolved this morning, thanks for reporting it.
-
Cleared Getting the same error since yesterday, if I click it enough times it manages to simulate it once but not the next time!
-
Cleared connection error again.
-
Cleared November 5 2018, Having this same issue :(
-
Toni Zaneti December, 29 2018, having this same issue :'(
-
alakinalexandr alakinalexandr Seems like this issue is back:
Unable to contact the code compilation service.
Please try again later or contact us if the problem persists -
Francis Deweirdt Same error again, only for circuits with Arduino, circuit without Arduino run OK.
Will wait and see ( posted around noon CET )
Typical US wakes up situation - all OK again around 3.30 pm CET
-
Stefany Barbosa Rojas I have the same problem right now
-
Wayne Losey Compiler was down for about 20 mins. Is back up and running now.
-
joedeangelis33 joedeangelis33 Seems down again now.
-
John Shuman Entire classroom is getting this error. Started at 12:10 central time
-
Robert Bazalik Down again...
-
Wayne Losey When this happens, try updating your code with a very simple change and retry simulation.
You might also try to refresh the browser window and see if it links to a new server.
-
shreyc shreyc Compiler is down again, i have tried both the suggestion
-
Dzurejdz Crnkic its down again...
-
Lazar Karbunar works
-
Test 1infoA Hello, this morning I have the same issue:
Unable to contact the code compilation service.
Please try again later or contact us if the problem persistsProblem is reported only when I try to start the simulation. Site is working well and https://health.autodesk.com/ doesn't show any issue with Tinkercad web site.
Currently working as expected.
-
Antreas Miltiadous Good evening,
I have the same issue. If you have any solutions please feel free to share them.
Thanks