0

Astable Multivibrator using IC 741 Not Working

Hello,

I am new to TinkerCAD. I tried building the following astable multivibrator circuit in TinkerCad using OpAmp IC 741:

I have taken R1 = 100 kOhm, R2 = R = 1 MOhm and C = 0.01 uF. The output vo is expected to be a square wave with 274 Hz frequency. When I tried running this in TinkerCAD, somehow it doesn't seem to be working properly. The output stays at 0 V and the two supply sources show 0 V output (even if I am setting them to 10 V) and they hit their maximum current setting. I traced through the circuit multiple times to see if I am shorting the sources anywhere, but that isn't the case.

I have tried other OpAmp circuits like Inverting Amplifier, Non-inverting Amplifier, Difference Amplifier, Instrumentation Amplifier, Voltage Follower and Bistable Multivibrator and they work properly.

Can anyone help me with this? 

Thanks in advance.

Regards,
A.S.

0 comments

Please sign in to leave a comment.